From: Microgravity Research Program Office
Posted: Tuesday, December 24, 2002
GMT Date: 358
Calendar Date: 12/24/02
Payloads currently on-board ISS:
BSTC, CGBA, CSLM-2, InSPACE, MAMS, MSG (facility), PFMI, SAMS, STES-10, SUBSA and ZCG.
MRPO payloads MAMS, SAMS, STES-10 and ZCG continue nominal, basically unattended, operations. BSTC, CGBA, CSLM-2, InSpace, PFMI, and SUBSA are inactive. MSG is inactive/failed, awaiting replacement parts. The first opportunity for replacements parts to be launched to the ISS will with Progress 10 scheduled for February 2nd. However this date is rather soft.
EXPRESS RACKS 1, 2 and 4 (ER1, ER2 & ER4) are powered and supporting payload operations. ER3 and ER5 are available to support payload operations but are currently inactive. ER3 power was turned on yesterday to support ground checkout of the rack in preparation for future payload operations. Checkout was successful except for the SAMS team attempts to communicate with their ER3 electronics equipment.
ADVASC relocation to EXPRESS Rack 4 occurred at 358/16:45 with no problems encountered.
MAMS is operating nominally in the quasi-steady mode. HiRAP is currently inactive. MAMS data is available on the acceleration measurement web page. MAMS is currently analyzing functionality of the HCOR.
All SAMS sensors in EXPRESS Racks are operating nominally. The SAMS sensor in the MSG is currently turned-off. The SAMS team attempts to communicate with their electronics equipment in ER3 during yesterdays checkout were not successful. The team is developing trouble-shooting procedures. SAMS data is also being posted to the acceleration measurement web page.
STES-10 health and status data is nominal. STES-10 is configured with diffusion-controlled chambers which require no crew operation activities.
ZCG furnace operations were initiated last Tuesday and the payload is down-linking nominal health and status information. The furnace is scheduled to operate until New-Years Day.
Week 4 (12/23-12/29) –Planning for this week was based on approximately
10 hours of crew time availability for NASA payload operations. ZCG furnace
operations are continuing. The new High-Rate Communications Outage Recorder
(HCOR), delivered by STS-113, is operating nominally. The HCOR was officially
put into record at 354/23:00:40. The HCOR is replacing the Medium rate
recorder (MCOR) that has been in use since Increment 2.
Week 5 (12/30-1/05) – Preliminary planning for this week is being based on approximately 10 hours of crew time availability for NASA payload operations. ZCG furnace operations will continue until the 1/1/03. The 2nd run for ZCG will start on the 1/3/03 to process spare autoclaves from the last two flights.
M. Vlasse, PhD, DSc
MRPO Increment Scientist
ARIS--Active Rack Isolation System
BCSS -- Biotechnology Cell Science Stowage
BSTC-- Biotechnology Specimen Temperature Controller (General status information on this payload will include coverage of the following items of support equipment: BTR, BCSS and GSM)
BTR -- Biotechnology Refrigerator
CGBA – Commercial Generic Bioprocessing Apparatus
ER1-- EXPRESS RACK 1
ER2 -- EXPRESS RACK 2
ER3 – EXPRESS RACK 3
ER4 – EXPRESS RACK 4
ER5 – EXPRESS RACK 5
GSM -- Gas Supply Module
HCOR -- High-Rate Communications Outage Recorder
InSPACE– Investigating the Structure of Paramagnetic Aggregates
ISS – International Space Station
MAMS -- Microgravity Acceleration Measurement System
MCOR -- Medium-Rate Communications Outage Recorder
MSG – Microgravity Science Glovebox
PFMI – Pore Formation and Mobility Investigation
PGBA – Plant Generic Bioprocessing Apparatus
SAMS -- Space Acceleration Measurement System II
STES – Protein Crystal Growth - Single Thermal Enclosure System
SUBSA – Solidification Using a Baffle in Sealed Ampoules
ZCG – Zeolite Crystal Growth
// end //