From: Microgravity Research Program Office
Posted: Tuesday, March 4, 2003
GMT Date: 063
Calendar Date: 03/04/03
Payloads currently on-board ISS:
BSTC, CGBA, CSLM-2, InSPACE, MAMS, MSG (facility), PFMI, SAMS, STES-10, SUBSA and ZCG.
MAMS, SAMS and STES-10 continue nominal, basically unattended, operations. BSTC, CGBA, CSLM-2, InSpace, PFMI, SUBSA and ZCG are inactive. MSG is in a trouble-shooting mode.
EXPRESS RACKS 1 and 4 (ER1 & ER4) are powered and supporting payload operations. ER2, ER3 & ER5 are currently powered down.
The MSG circuit breaker problem is continuing to be evaluated and troubleshooting procedures are being carefully implemented. Yesterday, one of the thirteen sensor cables disconnected last Friday was reconnected and MSG power was turned-on for several hours. No problem occurred so additional add-back sensor cable procedures will be implemented during this week in an attempt to isolate the connection that is causing an MSG circuit breaker to trip.
InSpace Coil assemblies have been confirmed to be ready to begin test operations when it is feasible to install the payload in the MSG.
MAMS is operating nominally in the quasi-steady mode. HiRAP is currently inactive. MAMS data is available on the acceleration measurement web page.
PFMI hardware removal from the MSG is contingent upon success of MSG trouble-shooting.
All SAMS sensors in EXPRESS RACKS are operating nominally. The SAMS sensor in the MSG is currently turned-off. SAMS data is also available on the acceleration measurement web page.
STES-10 health and status data is nominal. STES-10 is configured with diffusion-controlled chambers that require no crew operation activities.
Week 14 (3/3-3/9) – Planning for this week was based on approximately 7 hours of crew time for NASA payload operations. MSG trouble-shooting will continue during this week.
Week 15 (3/10-3/16) - Preliminary planning for this week is being based on approximately 1 hour of crew time for NASA payload operations. A SAMS sensor will be mounted on a cycle ergometer that will be operated while hard mounted to the US LAB structure to assess the effects it will have on the micro-gravity environment. The crew will spend much of this week preparing for a newly planned EVA during week 16.
M. Vlasse, PhD, DSc
PSR Increment Scientist
BCSS Biotechnology Cell Science Stowage
BSTC Biotechnology Specimen Temperature Controller (General status information on this payload will include coverage of the following items of support equipment: BTR, BCSS and GSM)
BTR Biotechnology Refrigerator
CGBA Commercial Generic Bioprocessing Apparatus
ER1 EXPRESS RACK 1
ER2 EXPRESS RACK 2
ER3 EXPRESS RACK 3
ER4 EXPRESS RACK 4
ER5 EXPRESS RACK 5
GSM Gas Supply Module
InSPACE Investigating the Structure of Paramagnetic Aggregates
MAMS Microgravity Acceleration Measurement System
MSG Microgravity Science Glovebox
PAO Public Affairs Office
PFMI Pore Formation and Mobility Investigation
PGB Plant Generic Bioprocessing Apparatus
PSR NASA Code U Physical Sciences Research Division
RIC Rack Interface Controller
SAMS Space Acceleration Measurement System II
SPD NASA Code U Space Products Development Division
STES Protein Crystal Growth - Single Thermal Enclosure System
SUBSA Solidification Using a Baffle in Sealed Ampoules
ZCG Zeolite Crystal Growth
// end //